Black Chain Wire Fencing
Sleek, low-glare and corrosion resistant, for boundaries where looks matter as much as security.
Learn morePress-formed spear top panels that deter climbers and lift a frontage, across Newcastle and the Hunter Region, NSW.
Press-formed spear top is a steel panel fence: vertical pickets running through horizontal rails, with the top of each picket pressed into a point. The pressed spear is formed from the picket itself rather than added on, which is why the line reads as one clean row instead of a row of fittings.
What you get is a genuine climbing deterrent that still looks like architecture. The points make the top of the fence unpleasant to grab or straddle, while the vertical rhythm and the open spacing keep a frontage light. On a home, a business or a public building it does the security job without turning the place into a compound.
Spear top earns its place where the fence is seen as much as it is relied on.
Panel fencing is specified in panels and posts, so the decisions sit in a few places.
Frontages commonly sit around 1.2 to 1.5 metres and security boundaries go higher. Height and spear profile together decide how much of a deterrent the top of the fence really is. Councils frequently set controls on front fence height and on what can sit at the top of a fence in a residential street, and those controls vary by area.
Galvanised steel is the base. A powder-coated finish over the galvanising adds colour and a further layer against corrosion, worth weighing up closer to the coast. Darker colours tend to recede and lighter ones stand out, so the finish is as much a decision about the frontage as about protection.
Panel fencing puts its load into the posts, so post size, spacing and footing depth follow the height of the panel and the ground it stands in. Gate posts and corners carry the most and are normally upsized. On a sloping block the panels are stepped or raked, depending on the fall.
Gates are built to match the panels so the spear line carries through the opening. A pedestrian gate on the path plus a wider gate or a pair of leaves at the driveway covers most sites. If the fence forms part of a pool barrier, the gate has to meet the NSW pool barrier requirements for opening direction, self closing and latching.
Two things: the pointed tops give nothing safe to grip or straddle, and there is no horizontal rail near the top to stand on. The taller the panel, the more that matters. It is a deterrent rather than a guarantee.
A vertical picket fence can form part of a pool enclosure, but the barrier and gates must satisfy the NSW pool barrier requirements, including limits on gaps, ground clearance, climbable features and gate operation. Whether a given panel suits depends on the pool and the property.
Yes. Powder coating over galvanised steel is the usual route and it comes in a range of standard colours. Tell us the look you are after and we will go through what suits the frontage and the exposure.
Chainwire covers long runs economically and keeps sightlines open, which suits yards and sporting fields. Spear top is harder to climb and looks considerably sharper, which is why it tends to win on frontages and public-facing boundaries.
Not sure this is the one? Here is the rest of what we install across Newcastle and the Hunter.
Sleek, low-glare and corrosion resistant, for boundaries where looks matter as much as security.
Learn more
The time-tested all-rounder, giving robust see-through security over long runs.
Learn more
Safety and stability for stairs, ramps and walkways, in a weatherproof finish.
Learn more
The rugged deterrent, topping off a perimeter on industrial and rural sites.
Learn moreTell us about the property and what you want the fence to do. We will recommend the right option and put together a quote.
Get a Quote